There’s a range of modes to choose from – you don’t even have to download image-editing software. See your pictures in 4K detail Connect the camera to a 4K Ultra HD TV to see your photos in dazzling clarity on a big screen. Top 4 Download periodically updates information of Sony DSC-HX400 Camera Firmware 2.10 full driver from the manufacturer, but some information may be slightly out-of-date. Using warez version of Sony DSC-HX400 Camera Firmware 2.10 driver is hazardous.

• Hikvision Camera Firmware
• Arlo Camera Firmware Update

• Connect the camera to the computer with the supplied USB cable. Note: When the camera is connected to the computer, the LCD screen of the camera turns OFF. Please proceed to the next step. Note: If the LCD screen of the camera dose not turn off, please try the following methods.

Try the following if this happens. - Disconnect the USB cable and connect it again. - If the computer has multiple USB terminals, try with the other terminals. (Your computer may have some USB terminals on the backside.) • Confirm is displayed on the task tray at the lower right corner of the computer screen. • After confirming the above, click Next on Firmware Updater. The screen below appears on Firmware Updater.

Hikvision Camera Firmware

Arlo Camera Firmware Update

• Check if the update is required • After confirming the screens on the above steps, click Next. The current version and the version after the upgrade appear on the lower left part of the screen. • After confirming Current version is Ver. 1.00 or 2.00, click Next. Note: If Current version is Ver. 2.10, the upgrade is not required. According to the message, stop the USB connection and click Finish.

Figure 5 • When the update is completed, the screen on Figure 6 appears. The camera will automatically restart. Note: A message “Recovering data. Installbuilder for mac. Please wait” may be displayed for a few minutes before restarting. Make sure the camera stays ON and wait until the LCD screen image appears again. Click [Finish] when the LCD screen image appears and disconnect the USB cable. Figure 6 • Turn off the camera, remove the battery pack, reinsert the battery and turn on the camera again.

Note: Never turn off the camera nor disconnect the USB cable while upgrading. • Complete the update When the upgrade is completed, the camera will restart automatically. 'Recovering data. ' maybe be displayed for a few minutes before restarting. Make sure the camera is turned ON and wait until the LCD screen appears again.